PRODUCT
Picture Scroll
Product Range
Order by Small Lot
3-D Machining
Soft Teflon Sealing Material
|
①Clean both flange faces.
②Peel off the paper and circle AFO seal and
stick it onto the central part of flange
surface. Cross the edges by 1-2 cm at bolt
part.
③Tighten the bolts diagonally by turns to
make it uniform tightness.
④Applicable sizes, standard thickness and
width after tightening the gasekts are as
follows.
|
Nominal Size
|
Flange Size
|
Standard Thickness After Tightening.
|
Standard Width After Tightening |
| MS-3 |
10A～50A |
0.2mm |
5mm |
MS-6
MS-9 |
65A～300A
over 300A |
0.4mm
0.7mm |
8mm
12mm |
| MS-12 |
Over 350A |
1.0mm |
17mm |
| Nominal Size |
Width |
Standard Length (per roll) |
★Other sizes available are; 14, 16, 20, 25mm
width and Tape Type of the following size.
1mm thick x 20, 30, 50 mm width
3mm thick x 20, 30, 50 mm width
★10 Rolls / Case
Thickness is around 1/2 of Width
|
| MS-3 |
3mm |
30m |
| MS-6 |
6mm |
15m |
| MS-9 |
9mm |
8m |
| MS-12 |
12mm |
5m |
| MS-9 |
9mm |
8m |
Flange Gasket
Sealant, Tank, Casing
Duct, Pressure Vessel, Heat Exchanger, Cooling
Tower
Reactor, Lining Vessel
Sealing Gaskets for equipment with large
diameter flanges.
☆Economical as you can cut it to required
length.
☆Compared with P.T.F.E. Full Face Gaskets
or Teflon Envelope gasket, cost reduction
of 40 - 50% can be achieve by introducing
this gasket.
| ITEM |
SPECIFICATIONS |
| MELTING POINT |
327 deg. C |
| GASKET FACTOR |
2 to 4 |
| MINIMUM TIGHTENING PRESSURE
|
3mm…75kg/cm2 |
| 6mm…100kg/cm2 |
| 9mm…125kg/cm2 |
| 12mm…150kg/cm2 |
| APPLICABLE PRESSURE
|
Gas...20kg/cm2 |
| Liquid...50kg/cm2 |
| APPLICABLE TEMPERATURE |
- 110 deg. C to + 260 deg. C |
| CHEMICAL RESISTANCE |
Acid, Alkali, Solvents |
| GOOD FOR EVERY FIELD OF INDUSTRY |
 |
※AFO Seal = Ask Flange Out Seal（Commonly Known as "fool seal as afo
means it in Japanese"）
General Sales Agent ASK Western Japan Sales Agent: Akitsu Industry Co., Ltd.
|